Thermilate

Warmtouch coating will make any handrail, and metal surface warm to the touch. It also prevents the handrails becoming slippery due to condensation & other outdoor conditions, allowing you to conform with the Building Regulations 2000 Law, which states “handrails need to be slip resistant and not cold to the touch”.

Warmtouch coating creates a thermal barrier, which is made up of a unique combination, and contains NanoCNB structures. Our unique combination utilises the very latest Nano and Insulating technologies. This makes the surface feel warmer to touch, and the texture non slip with a high quality semi gloss finish.

Warmtouch coating is ideal for use on surfaces such as: handrails, gates, fences, scaffolding tubes, street furniture and benches etc. as well as othermetal surfaces, tomake themwarmto touch. It also helps reduce condensation problems and is suitable for use both internally and externally.

It is also ideal for use externally on other metal surfaces, where the inside needs to remain cooler, e.g. railway signal boxes, metal containers, air conditioning units etc, the coating will reflect heat back out of the unit it is applied to, and help keep the inside cooler allowing it to function more efficiently.

Warmtouch coating contains a unique technology made up of NanoCNB structures. The structures are formed to trap air within them. These NanoCNB structures create a thermal barrier and when used on handrails will reflect the heat in your hand, back into your hand, rather than allowing the handrail to absorb the heat, thus making the surface warmer to touch and non slip.

Stir well before use.

Surface preparation: Make sure the surface is clean from any dust or dirt. All surface defects such as peeling, cracks and patches should be corrected before painting.

Application method: Apply 1 coat of primer suitable for the surface. Then apply 2 to 3 coats of Warmtouch coating with a brush or sprayer. (When you are using spray equipment you will need to remove the filters and increase the nozzle size to 0.019” – 0.026” due to presence of Thermilate technologies in the coating.)

Drying time: Under normal conditions, touch dry in 30 mins. Re-coat between 2-4 hours, depending upon environmental conditions.

Cleaning: Clean off all excess paint from brush or roller and thoroughly clean tools with white spirits as normal.

• Makes handrails & metal surfaces warm to the touch.

• Prevents handrails & surfaces becoming slippery due to condensation & other environmental conditions.

• Weatherproof.

• Reduces condensation on all metal surfaces.

• Abrasion resistant.

• High resistance to chemical and water leakage.

• Cost effective solution.

• Is suitable for both residential and commercial uses.

• Extremely simple to use & apply.

• Suitable for both internal and external use.

• Available in a range of colours.

• Allows you to conform to the building regulations law.

• Can be more durable than conventional coatings.

• Will help reflect heat, where internal cooler conditions are required.

• Reduces heat gain allowing units to run more efficiently.

Thermilate Warmtouch coating is available in six main colours, as listed below, in various quantities.

• Airforce Grey

• Blue Horizon

• Ebony

• Yellow

• White

We also offer the full range of 195 colours in the RAL colour range with a minimum order of 50lts for larger projects.

You can order Thermilate Warmtouch for brush or spray application.

Warmtouch is stored in in a dry well ventillated area, not in direct sunlight between the temperatures of 5 and 35 degrees centigrade.

After using Warmtouch you would need to use a paint thinner to clean your brushes. There are many on the market, you will need to use one that has Xylene in it.