Home Insulation
Checking your home's insulating system is one of the fastest and most cost-efficient ways to use a whole-house approach to reduce energy waste and maximize your energy dollars. A good insulating system includes a combination of products and construction techniques that provide a home with thermal performance, protect it against air infiltration, and control moisture. You can increase the comfort of your home while reducing your heating and cooling needs by up to 30% by investing just a few hundred pounds in proper insulation and weatherization products.
Where to Insulate Adding insulation in the areas shown here may be the best way to improve your home's energy efficiency.
Insulation
Should I insulate my home? First, check the insulation in your attic, ceilings, exterior and basement walls, floors, and crawl spaces to see if it meets the levels recommended for your area. Insulation is measured in R-values—the higher the R-value, the better your walls and roofs will resist heat transfer.
Although insulation can be made from a variety of materials, it usually comes in four types—batts, rolls, loose-fill, and rigid foam boards.
Each type is made to fit in a different part of your house. Batts are made to fit between the studs in your walls or between the joists of your ceilings or floors. Batts are usually made of fibre glass or rock wool. Fibre glass is manufactured from sand and recycled glass, and rock wool is made from basaltic rock and recycled material from steel mill wastes. Rolls or blankets are also usually made of fiber glass and can be laid over the floor in the attic. Loose-fill insulation, usually made of fibre glass, rock wool or cellulose, is blown into the attic or walls. Cellulose is usually made from recycled newsprint treated with fire-retardant chemicals.
Rigid foam boards are made of polyisocyanurate, extruded polystyrene (XPS), expanded polystyrene (EPS or beadboard), or other materials. These boards are lightweight, provide structural support, and generally have an R-value of 4 to 7 per inch. Rigid board insulation is made to be used in confined spaces such as exterior walls, basements, foundation and stem walls, concrete slabs, and cathedral ceilings.
The easiest and most cost-effective way to insulate your home is to add insulation in the attic. To find out if you have enough attic insulation, measure the thickness of insulation. If there is less than R-22 (7 inches of fibre glass or rock wool or 6 inches of cellulose) you could probably benefit by adding more.
If your attic has ample insulation and your home still feels drafty and cold in the winter or too warm in the summer, chances are you need to add insulation to the exterior walls as well. This is a more expensive measure that usually requires a contractor, but it may be worth the cost if you live in a very hot or cold climate.
You may also need to add insulation to your crawl space. Either the walls or the floor above the crawl space should be insulated.
New Construction
For new construction or home additions, R-11 to R-28 insulation for exterior walls is recommended for most of the country. To meet this recommendation, most homes and additions constructed with 2 x 4 walls require a combination of wall cavity insulation, such as batts, and insulating sheathing, or rigid foam boards. If you live in an area with an insulation recommendation that is greater than R-20, you may want to consider building with 2" x 6" framing instead of 2" x 4" framing to allow room for thicker wall cavity insulation—R-19 to R-21.
Weatherization
Warm air leaking into your home during the summer and out of your home during the winter can waste a substantial portion of your energy dollars. One of the quickest dollar-saving tasks you can do is caulk, seal, and weatherstrip all seams, cracks, and openings to the outside. You can save 10% or more on your energy bill by reducing the air leaks in your home.
How does the Air Escape
Air infilitrates in andout of your home through every hole, nook,and cranny. About one third of this air infiltrates through openings in your ceilings, walls and floors.
